RCI 2950
Key Features
-
Full Band Coverage - Covers the 10 Meter Amateur Band from 28.0000
to 29.6999 MHz.
-
All Mode Operation - Operates on USB, LSB, CW, AM and FM.
-
Brightness Control - Four Step LCD brightness control for easy viewing
under any condition.
-
Repeater Offset Switch - Gives you standard offsets for repeater
operation.
-
Programmable Frequencies - Allows you to program up to 10 individual
frequencies. Includes battery backup.
-
Built in Dual VFO - Choose steps of 10kHz, lkHz or 100Hz, manual
or scan
-
RIT - Receiver Incremental Tuning to fine tune the receive frequency
up to +/- 3kHz.
-
Squelch - Cuts off or eliminates receiver background noise in the
absence of incoming signals.
-
Noise Blanker - Greatly reduces repetitive impulse noise.
-
RF Gain Control - Reduces the gain of the receiver under strong
signal conditions to prevent overloading.
-
RF Power Output Selector - Lets you select transmitting output power
-
External Speaker Connection - Place a speaker anywhere for convenient
listening.
-
PA Mode - Use an external speaker for a mobile PA system.
-
LCD Display - Large, easy to read backlit LCD display.
-
Multi-Function LCD Meter - Indicates transmit power, receive signal
strength, modulation, SWR Calibration and SWR.
Specifications
General
-
Frequency Range: 28.0000~29.6999 MHz
-
Tuning Steps: 100Hz, 1kHz, 10kHz, 100kHz, 1MHz
-
Emission Types: USB, LSB(A3J), CW(A1), AM(A3), FM(F3)
-
Frequency Control: Phase-Locked Loop Synthesizer
-
Frequency Tolerance: 0.005%
-
Frequency Stability: 0.001%
-
Operating Temperature Range: 0 to 40 degrees C.
-
Antenna Impedance: 50 Ohms
-
Microphone: 400 Ohms, Dynamic PTT
-
Speaker: 8 Ohms, 2 Watts
-
Display: Digital Frequency, LCD
-
Meter Function: RF Output, Receive Signal Strength, Modulation,
SWR Calibration, SWR
-
Power Requirements: 13.8 Volt DC Negative Ground
Transmitter
-
Antenna Connector: UHF TYPE, 50 Ohm
-
RF Transmit Modes: USB, LSB, CW, AM, FM
-
RF Output Power: USB, LSB (25W); CW (8W); AM/FM (8W)
-
Spurious Emissions: -50dB
-
Carrier Suppression (SSB Modes): -50 dB
Receiver
-
Sensitivity for 10dB SINAD: AM 0.5uV
-
Sensitivity for 10dB SINAD: USB/LSB/CW 0.15uV
-
Sensitivity for 12dB SINAD: FM 0.25uV
-
Image Rejection Ratio: 65dB
-
AGC Figure of Merit: SSB/CW/AM 80dB for 50mV for 10dB Change in
Audio Output
-
Audio Output Power: 2.5 Watts